Recommended Clarinet 'Care Kit'

The Clarinet Care Kit

I was obliged to make some recommendations when a new beginner pupil has come to me with a clarinet and no additional accessories. The instrument had sticky pads and dirty keys. The following were my recommendations for a ‘care kit’ for years to come...

Thoughts - 

I have never felt the need to bombard a novice player with a bewildering and costly list of ‘extras’ or special equipment as they begin their study. A well made instrument, quality mouthpiece, appropriate reeds and the development of good habits and practice discipline rate much higher in my priorities. However, some items are sensible to purchase and introduced from the outset so that an instrument can be well cared for, serve better and its value maintained.

To address the sticky pads I would recommend cleaning paper. Cleaning paper is paper that has a finely ribbed texture and which has no sticky gum line like one would find with cigarette paper. It is used to absorb excess moisture when smaller tone holes have become blocked through a build up of water or as a first level treatment for the onset of the ‘tacky’ sound of a sticky pad. Cleaning paper can be used when pad surfaces are wet but the sheets are very thin and are likely to disintegrate if used under too great a pressure. Yamaha make a good product.

If the sticky pad problem persists move on to powder paper. The application of powder paper has been around for years as a treatment to reduce the surface adhesion of pads to tone holes on woodwind instrument, i.e. the familiar ‘tacky’ sound on the lifting of a pad that is caused by a build up of saliva or moisture on the surface from playing or even just during transport when keys are held shut for a long period. The powder residue on the paper creates a new barrier between the pad surface and the tone hole rim. Best applied when the pad surface is dry. Once again, Yamaha make a fine product.

For individual ‘problem pads’ I would recommend the BG Pad Dryers. These are a washable, micro fibre fabric product that provides an alternative to cigarette paper or cleaning paper to use for removal of moisture from tone holes. Simply insert between pad surface and tone hole and allow the moisture to be soaked up into the Pad Dryer. They are very absorbent and one Pad Dryer is intended to last for years of regular use.

To avoid moisture build up in the first place an absolute must is a good cleaning swab. Many types are available, good and bad, but my preference runs to the Dryer Swab which I helped design. I believe that this is simply the best clarinet swab on the market for both absorption and easy of use. Designed with an asymmetrical shape that makes pulling through the clarinet far easier and the brushed cotton fabric used is both highly absorbent and durable. The addition of a ‘pull back’ strap is a bonus ‘belt and braces’ extra to lend confidence when using the swab. High quality alternatives from BG and Yamaha are also available, each with different features. All of these are preferred to basic cotton or felt versions on the market.

Every clarinettist should use some type of cork grease to aid in the assembly of their instrument and to preserve the cork itself. Most brands are acceptable but some stand out for being either longer lasting or more effective. Rico and D’Addario greases are good, Elm bark grease from Doctor Slick products is a very ‘clean’ product and Selmer Tuning Slide and Cork Grease is deservedly recommended.

To clean around keywork a traditional shaving brush is the best quick answer to removal of dust and link from between keywork mechanisms on any clarinet (or other woodwind). Simply use the brush to lightly and quickly dislodge particles that otherwise might ‘gum up’ mechanisms or compromise the seating of the pads themselves. Regular use will not only keep an instrument looking better but playing better as well.

I like to see all players using mouthpiece patches to protect their mouthpiece and aid the formation of good habits for teeth placement. For most purposes I would recommend ‘thick’ patches, as they tend to be more durable and provide a greater cushion for the teeth. Thinner patches serve well to reduce mouthpiece wear and are almost unnoticeable to the player. Yamaha, BG and Kolbl are leading brands.

To protect reeds from damaged and warping once they begin to be used some type of reed storage device, other than that supplied by the reed manufacturer, should be used. Whether to hold 1, 2, 4, 6 or 8 reeds or more, something that will protect the reed tip, allow for air circulation during storage will help reeds to serve better and last longer. Many brands are available and some of these are small enough to store easily inside a case and some that also feature a humidity control.

Finally a silver polish cloth, used to wipe over keywork after playing to remove fingerprints reduce oxidation tarnish is a good practice. Denis Wick and others offer good, generous cloths for the purpose.

These products represent my suggestions for a best practice maintenance ‘kit’. As a player progresses and becomes more discriminating the enhancements to be found from experimentation with equipment including the upgrade of instruments, experiencing different mouthpiece options, learning about varieties of reeds and the effects of different ligature designs, barrels, bells, etc. are all waiting to be discovered – but after a good foundation in playing has been laid.

------------------

The tips and comments above are the result of many years of providing help and advice, my personal interest and study, and the teaching that I have done during my career. I have many colleagues and teachers to thank for sharing their thoughts and suggestions on this and other topics. In addition I am indebted to Woodwind & Reed, Cambridge ( www.wwr.co.uk ) where, in the course of helping customers, many of these concepts have been refined and have proven helpful. 

Thomas Dryer-Beers